What You Should Know About Skate Frames

Frame length

The quick answer is that a 273 mm wheelbase (typical for 90mm wheels) is needed for freestyle skating with large feet, and a 243 mm wheelbase (typical for 80mm wheels) is needed for freestyle skating with tiny feet.The same wheelbase applies while skating aggressively, but the wheels are smaller.You want your foot to be in proportion to your wheel base, which is the length of your frame. A relatively small wheel base makes a vehicle more maneuverable, accelerates more quickly, and prefers to travel at intermediate speeds.

If your wheel base is quite long, you will be more stable but less maneuverable. Although you will accelerate more slowly, it will be simpler to maintain high speeds once you reach them.

Torque

With a small, nimble frame, it is simpler to accelerate, climb slopes, or skate against the wind. It is more taxing, though, to travel at a high speed with the wind at your back for an extended period of time. similar to what a low gear in a vehicle or bike would do.Similar to a high gear in a vehicle or bicycle, a long, flat frame offers higher torque. Although it is more difficult to accelerate with, it is simpler to maintain high speeds.

Split

Split is the separation between the two wheels in the middle. It is a somewhat significant statistic since wheel bite decreases when wheels are spaced farther apart.

The UFS mounting standard is generally used to install aggressive skates. This indicates that the frame employs two bolts to attach to the boot in order to fit skates of all sizes. For all skates, the distance between the bolts is 165mm. The split of the groove is the same for all sizes of a certain frame because of how the UFS mount operates. The wheels cannot be spaced apart any farther since doing so would cause the mounting bolts to rub.

Grinding angle / wheel bite

When you are skating, the most annoying thing is when your wheel hits the top of the curb and you trip and fall.There are a few steps that may be taken to stop this.

Installing smaller wheels is the simplest way to prevent wheel bite. Even smaller wheels that are so small they cannot even roll can be placed in the center. They are referred to as grindwheels.There are frames with incredibly thick frame walls. This increases wheel protection and facilitates grinding.A frame spacer on some frames may be removed and reinserted upside down. Rocker frame spacers are what they are called. The height of the axle varies when the rocker frame spacer is turned upside down, which increases the amount of protection provided by the frame for the wheels.