Knowledge Of Roller Skating Tool Holder And How To Adjust It

Tool holder system concept

The blade holder system refers to the way the blade holder is matched with the shoe. Skateboard blade holders with different performances may have different appearances and specifications, but the blade holders installed in the same way are classified as the same blade holder system.

Common and general tool holder systems include UFS system, high and low rack system and other tool holder systems.

The UFS system is usually used in extreme shoes and street shoes. Most roller skates on the market currently use the high-low rack system, such as flat shoes, speed skates, casual shoes, etc.

Some brands of casual shoes and children's shoes have their own special knife holder system, and the knife holders cannot be interchanged between two pairs of shoes. Such knife holders are classified as other knife holder systems.

Tool holder system USF system

UFS system is the abbreviation of Universal Frame System.

Features of the UFS system: the front and rear heels are on the same level, there are grooves around the tool holder mounting hole, and it is stable with the two bosses on the sole, and generally cannot be displaced.

Advantages of UFS system: low heel, strong stability, very advantageous whether it is jumping or running.

The knife holders used in extreme shoes belong to the UFS knife holder system. Their knife holders are like a board. This is because the extreme roller skating will produce a lot of impact, and the knife holders must also be designed stronger. Groove for the lever.

When adjusting the speed skate tool holder. Mainly after turning the shoes up. Unscrew the screws on both sides of the top. After pushing down the rear handle, move the position of the knife holder freely. It can increase the stability of the knife holder when it is out of the way. And the inside is suitable for beginners to practice. At the same time, the shelf can be adjusted in normal times to prevent the phenomenon of turning feet.

The method of speed sliding tool holder adjustment

Generally speaking, when sliding with speed skates. If the tool holder is asymmetrical. Unscrew the small screw on top first. Just can change its position freely after pushing away a stopper on the knife rest again. And try to keep the shoes in the middle position. At the same time, don't change the wheels at will. So as not to affect the habit of sliding.

If the set shelf is inward. This will cause the landing point of the speed skate to be close to the center of gravity of the human body. This is more suitable for beginners to practice. The positions on both sides can be adjusted according to your own habits. The landing site of the wheels will be farther away from the center of gravity when the frame is out of the way. This increases stability.

Usually when sliding is very tiring, you can get a good relief by adjusting the shelf. If the thigh is very sore, it means that the wheel is out of the way. At this time, move the knife holder inward. At the same time, it is best to maintain a parallel state during normal taxiing. In addition, it can also prevent the occurrence of crooked feet.